Look for a two or three-pin header labeled or "CLR1" . It is usually located near the bottom right corner, next to the front audio header. There is no button. You have to move a jumper cap from pins 1-2 to 2-3 for ten seconds.
You have the proprietary PSU that fits it (Acer often uses non-standard 12-pin power). Replace it if: You want to use a standard case, standard fans, or overclocking. Acer Mg43m Motherboard Manual
You search for the manual, hoping for a detailed schematic of fan headers, overclocking menus, or RGB control. Look for a two or three-pin header labeled or "CLR1"
Spoiler alert: You aren't going to find it. You have to move a jumper cap from
The manual won't show you a photo of this. You just have to hunt for it with a flashlight. The MG43M is fine for a retro Windows 7 build or a basic office PC. It usually pairs with an Intel H61 or H67 chipset (check the large chip under the heatsink).
If you are reading this, you have likely just picked up a used Acer Aspire desktop, or you are trying to resurrect a dusty tower from the back of your office closet. Inside, you spotted the model number MG43M printed on the green PCB.