Cfesa Refrigeration — Practice Test

A defrost termination thermostat is wired in series with the: a) Evaporator fans b) Compressor contactor coil c) Defrost heater d) Liquid line solenoid Section 3: Troubleshooting & Diagnostics 7. A walk-in cooler has low suction pressure, low superheat, and a starved evaporator. The most likely cause is: a) Overcharge of refrigerant b) Liquid line restriction c) Bad compressor valves d) High evaporator fan speed

Superheat is measured at the: a) Condenser outlet b) Evaporator outlet c) Receiver inlet d) Compressor discharge cfesa refrigeration practice test

A reach-in freezer with hot gas defrost has frost only on the last pass of the evaporator. This indicates: a) Undercharge of refrigerant b) Defrost termination failed open c) TXV stuck open d) Non-condensables in the system A defrost termination thermostat is wired in series

The primary purpose of the accumulator is to: a) Store liquid refrigerant b) Prevent liquid slugging to the compressor c) Filter debris from oil d) Increase subcooling Section 2: Electrical & Controls 4. A potential relay is commonly used with which type of compressor motor? a) PSC b) CSIR c) CSCR d) Shaded pole This indicates: a) Undercharge of refrigerant b) Defrost

If a refrigeration system uses a low-pressure control (LPCO) for pump-down, the control is typically located: a) On the high side, before the receiver b) On the low side, after the evaporator c) At the compressor discharge line d) On the liquid line after the filter-drier

Here’s a for the CFESA Refrigeration Practice Test , designed to mirror the types of questions you’ll encounter on the Certified Food Equipment Service Association exam (refrigeration section). CFESA Refrigeration Practice Test – Sample Questions Section 1: Basic Refrigeration Cycle 1. In a vapor-compression refrigeration system, the component where refrigerant gives up its superheat and latent heat is the: a) Evaporator b) Compressor c) Condenser d) Metering device