Changing parameters incorrectly can cause unstable combustion, sooting, or overheating. Only qualified technicians should modify P01, P08, P10. 8. Maintenance Schedule (For Long Life) To keep the warranty valid and ensure safety, follow this schedule:
This long-form article serves as a complete instruction manual (instrukcia) covering installation prerequisites, control panel operation, daily use, parameter settings, maintenance schedules, error codes, and safety precautions. Always refer to the official Lambert documentation supplied with your unit, as regional gas and water regulations may vary. | Parameter | Value | |-----------|-------| | Type | C13, C33, C53 (concentric flue) | | Max heat output (heating) | 24 kW | | Min heat output (heating) | 5.4 kW | | DHW output (max) | 24 kW | | Efficiency class (heating) | ★★★ (ErP) | | NOx class | Class 6 | | DHW flow rate (ΔT=30°C) | ~11.4 l/min | | Inlet gas pressure (G20) | 20 mbar | | Electrical supply | 230V ~ 50Hz | | Power consumption | ~110 W | | IP rating | IPX4D | | Expansion vessel capacity | 6 l (pre-charge 1 bar) | | Max heating pressure | 3 bar | | DHW range | 30–60°C | | Heating flow temp range | 20–85°C | lambert lx 24 fi instrukcia
| P-code | Function | Default | Adjust range | |--------|----------|---------|---------------| | P01 | Maximum CH power | 24 kW | 5–24 | | P02 | Pump post-circulation time | 3 min | 0–10 | | P03 | Antifreeze activation temp | 5°C | 3–10 | | P05 | DHW preheating (comfort) | 0 (off) | 0/1 | | P08 | Minimum CH power | 5.4 kW | 3–10 | | P10 | Fan speed offset | 0 | -5 to +5 | Maintenance Schedule (For Long Life) To keep the
Introduction The Lambert LX 24 FI is a wall-hung, gas-fired condensing boiler designed for residential heating and domestic hot water (DHW) production. The "FI" designation typically indicates a forced flue (fan-assisted) model with a fully integrated electronic management system. This boiler is part of Lambert’s next-generation LX series, known for energy efficiency (ErP compliant), low NOx emissions, and compact design. The "FI" designation typically indicates a forced flue
A: Yes. The LX 24 FI works with volt-free (230V) or OpenTherm thermostats. Use terminals 3-4 for OpenTherm (if supported) or 1-2 for on/off.
A: Typically a dirty DHW plate heat exchanger or low flow rate. Clean the inlet filter first.